联系我们
名称：常州通风管道诚信加工厂
电话：xxx
手机：xxx
邮箱：xxx
地址：xxx
新闻动态
离心玻璃棉毡使用方法
离心玻璃棉毡使用方法
Usage of centrifugal glass wool felt
屋面施工
Roofing construction
1、铺放玻璃棉卷毡时，贴面朝向室内一侧，垂直于檩条，在一面屋檐处多留约20厘米的卷毡，用专用的夹具或双面胶带将其固定在最外侧檩条上。
1. When laying the glass wool felt roll, the veneer shall face the indoor side and be perpendicular to the purlin. An additional 20 cm felt roll shall be left at the eaves of one side, and it shall be fixed on the outermost purlin with a special clamp or double-sided tape.
2、放卷时保证对齐和张紧，将玻璃棉卷毡铺设至另一面屋檐处，同样多留20厘米的卷毡，用专用的夹具或双面胶带将其固定在最外侧檩条上。
2. During unwinding, ensure alignment and tension, lay the glass wool roll felt on the other side of the eaves, and reserve another 20cm roll felt, and fix it on the outermost purlin with special clamps or double-sided tape.
3、两卷棉之间通过在贴面飞边上用订书机装订的方法连接在一起。
3. The two rolls of cotton are connected by binding with stapler on the trimming flash.
4、安装屋面彩钢板，拆去屋檐处的专用夹具，用预留的20厘米贴面为玻璃棉收边。
4. Install the roof color steel plate, remove the special fixture at the eaves, and use the reserved 20cm veneer to close the edge of glass wool.
5、注意玻璃棉卷毡的张紧、对齐、卷与卷之间的接缝紧密，纵向需要搭接时，搭接头应安在排檩条处。
5. Pay attention to the tension and alignment of the glass wool felt roll, and the close joint between the roll and the roll. When the longitudinal overlap is required, the lap joint shall be installed at the purlin row.
6、根据工程需要，为避免冷桥的产生，可以考虑在檩条上垫上些硬质保温材料。
6. According to the needs of the project, in order to avoid the occurrence of cold bridge, it can be considered to pad some rigid thermal insulation materials on the purlin.
墙面施工
Wall construction
1、贴面朝向室内一侧，从屋檐放卷至墙脚，用双面胶带将玻璃棉固定在最下端的檩条上，多留20厘米。
1. Facing the indoor side, roll from the eaves to the foot of the wall, and fix the glass wool on the purlin at the bottom with double-sided tape, leaving an extra 20cm.
2、在玻璃棉卷毡超过墙顶檩条20厘米处将其截断，用双面胶带固定。
2. Cut off the glass wool felt 20 cm above the purlin on the wall top and fix it with double-sided tape.
3、将玻璃棉收边，安装墙面彩钢板。
3. Close the glass wool and install the wall color steel plate.
Usage of centrifugal glass wool felt
屋面施工
Roofing construction
1、铺放玻璃棉卷毡时，贴面朝向室内一侧，垂直于檩条，在一面屋檐处多留约20厘米的卷毡，用专用的夹具或双面胶带将其固定在最外侧檩条上。
1. When laying the glass wool felt roll, the veneer shall face the indoor side and be perpendicular to the purlin. An additional 20 cm felt roll shall be left at the eaves of one side, and it shall be fixed on the outermost purlin with a special clamp or double-sided tape.
2、放卷时保证对齐和张紧，将玻璃棉卷毡铺设至另一面屋檐处，同样多留20厘米的卷毡，用专用的夹具或双面胶带将其固定在最外侧檩条上。
2. During unwinding, ensure alignment and tension, lay the glass wool roll felt on the other side of the eaves, and reserve another 20cm roll felt, and fix it on the outermost purlin with special clamps or double-sided tape.
3、两卷棉之间通过在贴面飞边上用订书机装订的方法连接在一起。
3. The two rolls of cotton are connected by binding with stapler on the trimming flash.
4、安装屋面彩钢板，拆去屋檐处的专用夹具，用预留的20厘米贴面为玻璃棉收边。
4. Install the roof color steel plate, remove the special fixture at the eaves, and use the reserved 20cm veneer to close the edge of glass wool.
5、注意玻璃棉卷毡的张紧、对齐、卷与卷之间的接缝紧密，纵向需要搭接时，搭接头应安在排檩条处。
5. Pay attention to the tension and alignment of the glass wool felt roll, and the close joint between the roll and the roll. When the longitudinal overlap is required, the lap joint shall be installed at the purlin row.
6、根据工程需要，为避免冷桥的产生，可以考虑在檩条上垫上些硬质保温材料。
6. According to the needs of the project, in order to avoid the occurrence of cold bridge, it can be considered to pad some rigid thermal insulation materials on the purlin.
墙面施工
Wall construction
1、贴面朝向室内一侧，从屋檐放卷至墙脚，用双面胶带将玻璃棉固定在最下端的檩条上，多留20厘米。
1. Facing the indoor side, roll from the eaves to the foot of the wall, and fix the glass wool on the purlin at the bottom with double-sided tape, leaving an extra 20cm.
2、在玻璃棉卷毡超过墙顶檩条20厘米处将其截断，用双面胶带固定。
2. Cut off the glass wool felt 20 cm above the purlin on the wall top and fix it with double-sided tape.
3、将玻璃棉收边，安装墙面彩钢板。
3. Close the glass wool and install the wall color steel plate.
